High Wear-resistant & High Performance L4700-38231G0 Bus Engine Oil Pressure Sensor, Special Sensor for Commercial Bus Engine

Ⅰ. Product Purpose

This L4700-38231G0 oil pressure sensor is specially designed for commercial bus engines. It detects real-time engine lubricating oil pressure and converts pressure data into electrical signals, then transmits the signals to the instrument panel. It can remind drivers of abnormal oil pressure in time to avoid engine wear, jamming and other serious failures caused by insufficient lubrication.

Ⅱ. Product Features

  1. High wear-resistant internal structure, adaptable to long-time continuous heavy-load working conditions of bus engines.

  2. High performance sensing element, sensitive and accurate pressure signal feedback.

  3. Zinc alloy shell, good vibration resistance and corrosion resistance.

  4. High temperature resistant parts, stable operation under engine high temperature environment.

  5. Standard 2-pin terminal connector, convenient matching and wiring.

Ⅲ. Product Advantages

  1. Stable signal output, low failure rate during long service life.

  2. Wide applicable temperature range, suitable for different climate regions.

  3. Strict factory inspection to guarantee consistent product quality.

  4. Compatible with multiple commercial bus engine models.

Ⅳ. Installation Steps

  1. Turn off the engine and wait until the engine fully cools down to prevent scalding.

  2. Find the original oil pressure sensor installed on the engine block.

  3. Prepare suitable tools to unscrew and remove the old sensor carefully.

  4. Check the thread of the new L4700-38231G0 sensor, install sealing gasket if needed.

  5. Screw the new sensor manually first, then tighten it with a tool with proper torque. Do not over-tighten to avoid thread damage.

  6. Connect the wiring plug firmly to the sensor terminals.

  7. Start the engine and check for oil leakage at the installation position.

  8. Observe the dashboard to confirm the oil pressure signal displays normally.

Ⅴ. Notes

  1. Installation must be carried out when the engine is cold. Never operate on a hot engine.

  2. Do not use excessive force when tightening the sensor, which may crack the housing or damage the thread.

  3. Ensure the wiring connector is locked tightly; loose plug will cause signal abnormality or alarm.

  4. Check the sealing gasket for aging or damage before installation, replace it if necessary to prevent oil leakage.

  5. Keep the sensor away from sharp hard objects to avoid shell deformation and internal component damage.

  6. If oil leakage or abnormal pressure alarm appears after installation, stop the vehicle and inspect immediately.

  7. This sensor model is L4700-38231G0, please confirm compatibility before purchase and installation.